Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-32
Table 3-2. The slip Command Prompts (continued)
Prompt Description
Enter remote
endpoint address
Specifies the IP address of the remote end of the
SLIP interface.
Enter remote load/
dump host address
Specifies the IP address of the remote host to
which load and dump requests are sent. This
address is required only if the remote host is a
gateway and not the load host. By default, this is
the same as the remote end-point address.
Should this interface
be used for memory
dumps
Enables the Remote Annex 2000 to use a SLIP
interface for memory dumps. The default is y.
Enter the baud rate Specifies the baud rate of the serial interface. The
default is 9600.
Enter the number of
stop bits
Pressing the key accepts the default (one).
Generally, SLIP implementations require
the default.
Enter the parity
Pressing the key accepts the default
(none). Generally, SLIP implementations require
the default.
Return
Return