Installation guide

3-5Remote Annex 2000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
addr
The addr command displays and sets several Remote Annex 2000
operating parameters (EEPROM values) relevant to IP network
addressing:
❑ Internet address.
❑ Subnet mask.
❑ Broadcast address.
❑ Preferred Load Host address.
❑ Preferred Dump Host address.
❑ Load/Dump Gateway address.
❑ Type of IP Packet encapsulation.
❑ Load Broadcast
Theaddr -d command also displays the unit’s ROM-resident Ethernet
address in hexadecimal notation (see the Remote Annex Administrator’s
Guide for UNIX). The command syntax is:
addr [–d]
If you enter the addr command without the –d argument, the console
prompts you for each Internet address. Enter Internet addresses using
the standard decimal dot notation.
The addr –d command displays the Remote Annex 2000’s Ethernet
address, IP address, subnet mask, broadcast address, preferred load
host address, preferred dump host address, load/dump gateway
address, IP encapsulation type, and Load Broadcast. The addr -d
command cannot be used to make changes to any of the
displayed parameters.