Installation guide

3-3Remote Annex 2000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
Table 3-1. ROM Monitor Commands (continued)
(continued on next page)
Command/
Abbreviation Description Use
boot [-l] [<file>] Erases the existing
Flash memory and
copies a new image to
Flash.
Upgrading or replacing
the Flash image.
config Displays the current
hardware
configuration and
revision levels.
Identifying your
hardware, memory, and
ROM version.
console-baud Changes the console
port’s baud rate.
Configuring the console
port for remote
maintenance.
erase Erases non-volatile
memory.
Loading a new image and
need to erase the old
image.
help Displays the list of
ROM Monitor
commands.
Referencing the ROM
monitor commands.
image [-d | <file>] Displays and/or sets
the load image and
tftp load dump names.
Loading an image that
differs from the default.
ipx [-d] Displays and sets
EEPROM values
relevant to Novell/IPX
network addressing,
including the IPX
load/dump file server.
Changing Novell/IPX
configuration parameters.
lat_key [-d] Sets the LAT key. Connecting to a DEC
VMS host.