Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-18
3 Enter yes and continue the installation.
4 Enter yes if you have backed up your system disk.
5 Enter the device on which your distribution medium is loaded.
6 Enter
* for the products to be processed.
7 Press to indicate none for installation options.
8 Enter yes if you have mounted the software medium on the
appropriate device.
The Remote Annex parameter disabled_modules disables
specified software modules and frees memory space for use by
the system.
The default Remote Annex setting for disabled_modules
includes vci which disables the Remote Annex interface for
VMS environments along with the following commands:
backwards,change,clear,crash,define,disconnect, forward,
list, logout, resume, set, and show.
Booting the Remote Annex 2000 from a VAX VMS load host
automatically enables vci. The following message appears in
the syslog file: MOP Booting, vci enabled. On subsequent boots
(regardless of the type of load host; e.g., VMS or UNIX), vci
remains enabled. To disable vci, you must re-enter it in the
disabled_modules parameter (for more details, see the Remote
Annex Administrator’s Guide for UNIX).
If the disabled_modules parameter is set to vci, even if the
cli_interface parameter is set to vci, none of the VMS-specific
commands will be available, the Local > prompt will not be
displayed, and the Username> prompt will not appear upon
port reset.
Return