Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-16
3 If you are booting the Remote Annex 2000 using a Serial Line Internet
Protocol (SLIP) network interface, you must:
❑ Use the slip command to modify the port parameters for
the SLIP network interface (see slip on page 3-30).
❑ Use the sequence command to list the SLIP network
interface in the load/dump interface list (see sequence on
page 3-28).
4 Execute the boot command (see boot on page 3-8).
After successful execution of the boot command, the Remote
Annex 2000 is up and running.
Installing to and Loading from a VAX VMS Load Host
This section contains a description of what you need to do to install
the Remote Annex 2000’s operational software and image on a VAX
VMS Load Host. Refer to the Annex Interface for VMS Environments
Administrator’s Guide and the Annex Interface for VMS Environments
User’s Guide for additional information.
This product cannot be installed on an AXP system. This section
contains the following subsections:
❑ Installing the Operational Software and Image on a VAX
VMS Load Host.
❑ Configuring NCP for Downloading.
❑ Configuring for Crash Dump Support.
❑ Customizing for Multiple Remote Annex Images.