Installation guide

2-13Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
Installing the Operational Software and Loading the
Image
Use this section if you have successfully connected the Remote Annex
2000 to your LAN.
This section describes:
❑ How to install the Remote Annex 2000’s operational software
and image on a device that resides on a network accessible
to the Remote Annex 2000.
❑ How to download the operational image from the network
device to the Remote Annex 2000.
This section contains the following subsections:
❑ Installing to and Loading from a Novell Server.
❑ Installing to and Loading from a UNIX Host.
❑ Installing to and Loading from a VAX VMS Host.
Installing to and Loading from a Novell Server
This section contains a description of what you need to do to install
the Remote Annex 2000’s operational software and image on a Novell
Server. Proceed as follows:
1 Log into your Novell server as SUPERVISOR or equivalent.
2 Insert the Network Administrator Program Install Disk into your PC’s
floppy drive.
3 Change to your PC’s floppy drive (usually drive A or B).