Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-12
3 Verify the Remote Annex 2000’s hardware configuration.
At the monitor prompt on the console, type config and press
. The screen display looks like this:
4 Record the Remote Annex 2000’s Ethernet address for future
reference.
At the monitor prompt type addr –d and press . The screen
display should look like this:
Return
monitor:: config
REVISION/CONFIGURATION INFORMATION
ROM Software Rev: 0901
Board ID: 56 Board Type: Remote Annex 2000
CPU Type: 486SXLC2 Ethernet Address: 00-80-2D-00-C6-1E
Memory Size: 4 Meg
Flash Size: 2 Meg Flash ID: 8989
EEPROM Size: 32736
Installed Alternate Interface: ThinNet
ASYNC Config
Number of Ports: 16
Max Port Speed: 115.2 Kbps
Return
monitor:: addr -d
Ethernet address (hex): 00-80-2D-00-18-B6
Internet address: <uninitialized>
Subnet mask: 255.255.0.0
Broadcast address: 0.0.0.0
Preferred Load Host address: <any host>
Preferred Dump Host address: 0.0.0.0
Load/Dump Gateway address: <uninitialized>
Type of IP packet encapsulation: <ethernet>
Load Broadcast: Y