Installation guide

2-11Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
Press the button located on the Remote Annex 2000 front
panel. The Test LED lights when the unit enters Test Mode (see
Figure 2-9).
Figure 2-9. Setting the Remote Annex 2000 to Test Mode
Next, the Remote Annex 2000 runs diagnostic tests, causing the
Active LED to flash; the status LEDs display the test number
progression. If the diagnostics complete successfully, the Unit,
Net, and Attn LEDs light, and the ROM Monitor prompt appears
on the console terminal (attached to Port 1).
If the Unit, Net, and Attn LEDs do not light within one minute,
one of the following failures has occurred:
❑ Remote Annex 2000 hardware failure: Unit and Attn
LEDs flash. Contact technical support.
❑ Network or network interface failure: the Net and Active
LEDs flash; the error message displays on the console.
If a network or network interface failure occurs, typing q accesses the
ROM Monitor prompt. Check the network connection (also, see
net
on page 3-22).
Chapter 4 provides troubleshooting information.
Test
STATUS
POWER UNIT NET ATTN LOAD ACTIVE 12345678
TEST
Test 
Button