Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-10
.
Figure 2-8. Connecting the Power Cord
The Remote Annex 2000 now runs its ROM-resident power-up
diagnostics. The LEDs light and then turn off, except for the
Power and some status LEDs.
2 Set the Remote Annex 2000 to Test Mode.
Pressing the button within 3 seconds of
powering up puts the Remote Annex 2000 into test
mode. To enter test mode when the Annex is already
running, hold down the button until the
Power LED blinks rapidly, then release the
button and press it again within 3 seconds. This
second method resets the Annex, so warn users
before you do it.
Test
Test
Test