Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-8
3 Turn on the Console Terminal and set the terminal to 9600 baud,
eight data bits, no parity, one stop bit, and XON/XOFF flow control.
The ROM Monitor assumes that this terminal is CRT-based and
displays the backspace (BS) character accordingly. See Chapter 3
for information on invoking the ROM monitor.
Connecting Serial Devices
The Remote Annex 2000 provides 4, 8, or 16 asynchronous RJ45 serial
ports, depending on the device configuration. To attach the serial port
cables:
1 Insert the RJ45 end of the cable into one of the serial ports located
on the Remote Annex 2000’s rear panel (see
Figure 2-7).
2 Connect the opposite end of the serial port cable to your serial
device.
Figure 2-7. Connecting the Serial Port Cable to the Remote Annex 2000
WARNING