Installation guide

2-7Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
1 Connect the Console Terminal’s I/O connector to the RJ-45 cable
(the accessory kit includes a cable) using a Telco RJ wire to a DB-25
DTE drop adapter (see
Figure 2-5).
Figure 2-5. Connecting the RJ-45 Cable to the DB-25 Drop Adapter
2 Plug the RJ-45 connector into the console port (Port 1), located on
the back panel of the Remote Annex 2000 (
Figure 2-6).
When the connector clicks into place, the connection is secure.
Appendix A describes the console port’s signal/pin allocation.
Figure 2-6. Connecting a Console Terminal