Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-6
3 Verify that the Link Indicator is green.
The green link indicator LED next to the 10BaseT connector goes
on when power is applied and an active 10BaseT network
segment is plugged in.
Figure 2-4. Connecting Twisted Pair Ethernet Cable
Do not confuse this connector with the console port RJ-45
connector (Port 1).
Connecting a Console Terminal
A console terminal is used to access the ROM Monitor and boot the
Remote Annex 2000 for the first time. Follow the steps in this section
to connect a console terminal to the console port (Port 1) located on
the rear panel of the Remote Annex 2000.