Installation guide

2-5Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
3 Push the slide mechanism to the left to secure the connection.
Figure 2-3. Connecting Thick Ethernet Cable
Connecting Twisted Pair Ethernet (10BaseT) Cable
Follow the steps in this section to connect a Twisted Pair (10BaseT)
Ethernet cable to the Remote Annex 2000 (see
Figure 2-4):
1 Insert the RJ-45 connector located on the Twisted Pair Ethernet cable
into the 10BaseT connector on the rear panel of the Remote
Annex 2000.
2 When the connector clicks into place, the connection is secure.