Installation guide

Remote Annex 2000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 2000
2-4
3 Twist the sleeve on the T-connector clockwise to lock the connection
in place.
Figure 2-2. Connecting Thin Ethernet Cable
Connecting Thick Ethernet (10Base5) Cable
To connect to Thick Ethernet (10Base5) or equivalent transceiver
cable, you must have already installed a 10Base5 Ethernet network
cable. Follow these steps to connect the Remote Annex 2000 to a Thick
Ethernet cable (see
Figure 2-3):
1 Make sure the Thick Ethernet cable is plugged into the Ethernet
network.
2 Push the slide mechanism on the Remote Annex 2000’s Thick
Ethernet connector to the right and plug in the transceiver cable.