Installation guide

Index
Index-3Remote Annex 2000 Hardware Installation Guide
option_key -d command 3-24
P
physical characteristics
description of 1-12
ping command 3-25
examples 3-25
port pin/signal allocations A-1
ports command 3-26
power select switch 1-12
power supply 1-12
power switch
description of 1-11
power-up
applying power 2-9
failures during 2-11
in normal mode 4-2
in test mode 4-7
instructions 2-9
running self-tests 2-11
self-testing procedures during 2-9
sequence 4-2
setting to test mode 2-11
preferred load host
setting 3-7
printing conventions xiv
R
RARP 2-21
rarp 2-23
rear clearance
requirement 1-14
rear panel
16-port 1-10
4-port 1-8
8-port 1-9
components 1-10
description of 1-8
rear panel options 1-8
remote access review 1-1
ROM Monitor
command syntax 3-2
description of 1-5
list of commands 3-2
ROM Monitor vs. Console Monitor 1-5
S
self-booting 2-24
self-booting without a Local Ethernet Interface 2-
24
sequence command 3-28
examples 3-28
serial cable
wiring diagrams B-1
Serial Devices 2-8
serial devices
connecting 2-8
serial port A-1
cable wiring B-1
cable wiring diagrams B-1
pin/signal allocations A-2
Serial port loopback connector
wiring B-4
setting
boot sequence 3-28
broadcast address 3-7
Internet address 3-7
IP encapsulation 3-7
load/dump gateway address 3-7
preferred load host address 3-7
SLIP parameters 3-30
subnet mask 3-7
shielded cable
source B-1
wiring B-1
size 1-12
SLIP
parameters 3-31
slip command 3-30
example 3-30, 3-31
software installation
executing boot command 2-16
setting boot sequence 2-16
setting initial boot parameters 2-15
setting Internet address 2-15
setting SLIP parameters 2-16
stats command 3-33
example 3-33
status indicators 1-8
subnet mask
setting 3-7
Support Source CD xx