Installation guide

xiiiRemote Annex 2000 Hardware Installation Guide
Preface
This guide describes how to install a Remote Annex 2000 on a local
area network (LAN).
See the Annex Quick Start or the Remote Annex Software Installation
Notes that come with your Remote Annex 2000 for a description of
the software installation. See the Remote Annex Administrator’s Guide
for UNIX for configuration information.
About this Guide
This guide includes the following chapters and appendices:
Chapter 1 Introduction
This chapter contains an overview of the Remote
Annex 2000; it describes the hardware features and
firmware functions.
Chapter 2 Installing the Remote Annex 2000
This chapter describes how to install the Remote
Annex 2000 on a LAN, and how to confirm its
operating status.
Chapter 3 ROM Monitor Commands
This chapter describes the ROM Monitor commands
that modify specific configuration parameters,
perform diagnostic tests, and load the
operational code.
Chapter 4 Troubleshooting Procedures
This chapter provides troubleshooting and
verification procedures.
Appendix A Port Pin/Signal Allocations
This appendix details the connectors located on the
rear panel of the Remote Annex 2000.