Technical data

5
Remote Annex Quick Start for Windows
166-024-858 Rev. A
Refer to Installing Remote Annex Network Software for Windows for
information about installing the na and Quick2Config Annex software
on Windows platforms.
If you are installing Quick2Config on a Windows 3.1 or Windows for
Workgroups 3.11 platform, you may be required to install additional
software that is provided on the CD-ROM. See Installing Remote
Annex Network Software for Windows for details.
Hardware Setup
To set up the Remote Annex hardware:
1. Connect the power and connect the Remote Annex to the
network. If you are setting up a Remote Annex 6300,
connect CSU (DTE) to the Remote Annex and connect CSU
(Net) to the PRI Line.
2. Connect the console cable and terminal.
The Remote Annex 4000, 6100, and 6300 have a dedicated
console port.
The Remote Annex 2000 uses port 1 as its console port.
The Remote Annex 539x uses the service port on the 5000
chassis as the console port.
3. Set the terminal to 9600 bps, 8 bits, 1 stop bit, no parity and
no flow control.
4. For the Remote Annex 2000 or Remote Annex 4000, turn on
the unit and immediately press the button on the
front panel. Make sure the Test LED comes on.
For the Remote Annex 539x, Remote Annex 6100 and
Remote Annex 6300, turn on the unit and immediately press
the button. Make sure the Setup LED comes on.
5. If the LED next to the button is not lit, press
again.
Test
Setup
Test Test