Technical data
Table Of Contents
- Contents
- Before Installing the Software
- Software Installation
- Hardware Setup
- Network Address
- Booting the Remote Annex
- Configuring the Remote Annex
- Remote Annex 2000 Remote Annex 4000 Remote Annex 5...
- Using Quick2Config Annex
- 1. Invoke na, configure the Remote Annex to accept...
- 2. Click on the Quick2Config icon to open the appl...
- 3. Choose File > Add Annex, enter the name or IP a...
- 4. Select the Annex and use the tab windows to rev...
- 5. Select each Annex port and use the tab windows ...
- 6. Choose Help > Contents or click on in the dialo...
- Using the na Utility
- Using Quick2Config Annex
- Inbound Modem
- Outbound Modem
- Inbound/Outbound
- Centronics Interface
- Dataproducts Interface
- Remote Annex 2000 Remote Annex 4000 Remote Annex 5...
- Configuring the Remote Annex 6300
- Initial Setup with na
- Setting Up PRI Channels
- 1. Click on the Quick2Config icon to open the appl...
- 2. Choose File > Add Annex, enter the name or IP a...
- 3. Click on the Annex in the tree view.
- 4. Choose Config > Edit Configuration File to modi...
- 5. Modify the telephone numbers for the Sync PPP a...
- 6. Copy and modify blocks for other telephone numb...
- 7. Select the Annex and use the Call Defaults tab ...
- 8. Choose Autodetect in the Mode box and enter the...
- 9. Choose Help > Contents or click on in the dialo...
- Configuring Security
166-024-858 Rev. A
Remote Annex Quick Start for Windows
4
To install Remote Annex software on the server:
1. Put the CD-ROM into the Windows NT server’s CD drive.
2. Use the File Manager to select the CD-ROM disk.
3. Double-click on the setup.exe file.
4. Once the setup program runs, the Welcome window
appears. Click to continue the installation process.
Refer to the Installing Remote Annex Network Software for Windows for
installation details.
Workstation Software
Remote Annex software can be installed on other Windows platforms on
the Windows NT network:
• The na and Quick2Config Annex software can be loaded on
Windows NT Workstations (3.51 or 4.0) and on Windows 95
platforms.
• Quick2Config Annex can be installed on Windows for
Workgroups 3.11 and Windows 3.1 systems.
To install Quick2Config Annex on a Windows platform:
1. Put the CD-ROM into the Windows NT server’s CD drive.
2. Use the File Manager to select the CD-ROM disk.
3. Double-click on the setup.exe file.
4. Follow the dialog box instructions to select Install Software
and then Quick2Config Annex.
5. When prompted for an installation directory, accept the
default directory for each software module.
Next