Technical data

Table Of Contents

Remote Annex Quick Start for Windows

166-024-858 Rev. A

Quick2Conﬁg opens an editor with the default conﬁguration

ﬁle. The Session Parameter Blocks are listed in the %pri

section.

%pri

begin_session sync

called_no 123-555-1212

bearer data

call_action sync

set mode ppp

end_session

begin_session v120

called_no 123-555-1313

bearer data

call_action v120

set mode auto_detect

end_session

begin_session default

call_action modem

set mode auto_detect

end_session

5. Modify the telephone numbers for the Sync PPP and V120

blocks to reﬂect the numbers used to dial the Annex.

6. Copy and modify blocks for other telephone numbers.

7. Select the Annex and use the Call Defaults tab window to set

parameters not speciﬁed in the Session Parameter Blocks.

8. Choose Autodetect in the Mode box and enter the Annex

address as the Local address in the Dial-up Address box.

9. Choose Help > Contents or click on in the dialog boxes

for detailed information about using Quick2Conﬁg Annex.

Refer to the application’s on-line help or to Installing Remote

Annex Network Software for Windows for conﬁguration

examples.

Help