Technical data

166-024-858 Rev. A
Remote Annex Quick Start for Windows
8
Configuring the Remote Annex
Remote Annex 2000
Remote Annex 4000
Remote Annex 5390
Remote Annex 5391
Remote Annex 6100
You can configure Annex ports using either Quick2Config Annex or the
na utilities. The following examples apply to non-RA 6300 Annexes that
have been installed by using default selections. There is a separate
configuration procedure for the Remote Annex 6300 and Remote Annex
5393.
Using Quick2Config Annex
To configure Remote Annex ports using Quick2Config Annex:
1. Invoke na, configure the Remote Annex to accept and
process SNMP command sets, and exit na.
% na
command: annex 129.9.200.62
command: set annex allow_snmp_sets y
command: boot
command: quit
2. Click on the Quick2Config icon to open the application.
3. Choose File > Add Annex, enter the name or IP address of
the Remote Annex in the dialog box, and click on .
Quick2Config Annex lists the Annex in the tree view on the left
and displays a set of tab windows on the right.
4. Select the Annex and use the tab windows to review and
modify Annex parameters.
5. Select each Annex port and use the tab windows to
configure the port as a terminal or modem port.
6. Choose Help > Contents or click on in the dialog box
for detailed information on using Quick2Config Annex.
Refer to the application’s on-line help or to Installing Remote
Annex Network Software for Windows for configuration
examples.
OK
Help