Technical data

Installing and Operating BayStack ARN Routers
3-10
114200-D Rev 00
• After completing the diagnostic testing procedure, the boot process begins.
The Run and Boot LEDs indicate the boot status as shown in Table 3-15
.
• After the boot process completes, the Run LED lights and the Boot LED turns
off, indicating that the ARN is operational.
If the LEDs on the ARN light in this sequence, your installation is successful.
Contact your network administrator to verify that the ARN is now connected to
the network.
If the LEDs do not light in this sequence, your network administrator can refer to
Configuring BayStack Remote Access to help troubleshoot the problem.
If you need additional assistance, contact your local Bay Networks Technical
Solutions Center.
Table 3-15. Boot Status LEDs
Boot Status Run LED Boot LED
Local Boot Off On
Netboot (attempting) Off Flashing
Netboot (downloading) Flashing On
Interrupted (using ARN monitor) Flashing Flashing
Note:
If the ARN does not contain an expansion module, an adapter module, a
redundant power supply, a data collection module, or a flash card, the LEDs
associated with these components remain off.