Technical data

Starting the ARN

114200-D Rev 00

2-15

Enter the following command and press the Return key to run the

Quick-Start script:

run inst_arn.bat

The Quick-Start script begins running.

Using your completed Quick-Start worksheet from Appendix B, enter the

appropriate network information as the prompts appear.

The ARN uses this information to configure interfaces to the network.

For sample Quick-Start screen output and for information on using

Quick-Start commands, see Appendix B.

Choose whether you want to configure another module/port.

Entering

n stops the Quick-Start script and returns you to the Technician

interface prompt. Entering

y allows you to configure another module/port.

Once the install script completes, the ARN starts bridging and routing traffic.

Ensure that the ARN is successfully connected to your network.

To verify that the ARN is now connected to the network, contact your network

administrator. To troubleshoot any problems, your network administrator can

refer to Configuring BayStack Remote Access.

If you need additional assistance, contact your local Bay Networks Technical

Solutions Center.

Note:

After connecting the ARN to the network, you can replace the

management console connection with a modem connection to enable remote

dial-in access.