Technical data

Installing and Operating BayStack ARN Routers
1-32
114200-D Rev 00
Connecting the Power Cable
To connect the power cable to the ARN, complete these steps:
1.
Connect the power cable to the power connector on the left side of the
ARN back panel (Figure 1-25)
.
Figure 1-25. Connecting the Power Cable to the ARN
2.
Connect the remote end of the power cable to a grounded outlet.
Danger:
Be sure that the power switch on the ARN back panel is in the OFF
(0) position before you connect the power cable.
Note:
For information about connecting a redundant power supply to the
ARN, refer to the documentation that came with your power supply.
Power switch (off)
Redundant Power
U
L
U
L
100-240~
1.2A
50-60Hz
To redundant power supply
To power outlet