Specifications

9031398 E3 NMM Management Views
4-3
NMM Agent Configuration View
Configuration Load Source
Displays the source from which to load configuration information at the next
boot. Table 4-2 lists values which are valid entries, and descriptions of each
value.
When “local only” is specified, the configuration information is loaded from
local storage. If the local configuration is not valid, then BOOTP is used for
the IP stack.
In IPX only mode, the IP address could be 0.0.0.0; IPX does not rely on the IP
address. The agent checks the IPX address, and if the network number of the
IPX address is equal to 0 the agent uses SAP.
When “net only” is specified, the configuration information will be downloaded
from the network only. The configuration information will never be loaded
from local storage, even if downloading fails and the local configuration
information exists.
When “net with local backup” is specified, a download of the configuration
information will be tried over the network. If the network download fails, then
the configuration information will be loaded from local storage.
Current Gateway
Displays the IP address of the current default gateway (router). If not used,
then this object has the value of 0.0.0.0.
Current Protocol
Displays the transport protocol over which the agent image and configuration
information were last loaded. Table 4-4 lists status values which are valid
entries, and descriptions of each value.
Table 4-2. Configuration Load Source Values
Value Description
local only get from local storage
net only load from the network
net with local backup try using network and if it fails then use local information
other not applicable or some other case
Table 4-3. Current Protocol Status Values
Value Description
ip gotten from the network using a load protocol over IP
other reserved unknown or some other protocol