Specifications

Modeling the SynOptics Series 5000 Hub
Introduction
1-14
SynOptics Series 5000
Management Module Guide
the Application view into their respective LAN_802_3, LAN_802_5, or FDDI
network models.
To set up a network topology for the SynOptics Series 5000 hub, do the
following:
1. Highlight the large or small device icon and select Application from the
Icon Subviews menu, or double-click the icon’s model type label.
2. Edit/Copy the Syn5EnetRptr, Syn5FDDIMac, or Syn5TRRptr icon
associated with the network model to be monitored.
3. Access the LAN_802_3, LAN_802_5, or FDDI network model’s Topology
view by highlighting the network icon and select Topology from the Icon
Subviews menu, or double-click the icon’s down arrow.
4. Edit/Paste the Syn5EnetRptr, Syn5FDDIMac, or Syn5TRRptr icon
associated with that network model into the network model’s Topology
view.
Figure 1-4 shows an example of a FDDI and LAN_802_3 network model
connected by a router with SynOptics FDDI and Ethernet repeaters models
pasted into the network models.
Cabletron recommends creation of the HubSyn5xxx device model in the
Location View. The model represents the chassis and is not topologically
significant. There is no Device Topology (DevTop) View available for the model
as it may represent several repeater elements, each having its own
connectivity.