Specifications

Port Profile View
FDDI Modules SynOptics Series 5000
C-8 Management Module Guide
Attachment
Displays the number specifying the location of the attachment on the module.
Current Attachment
Provides a button displaying (and allowing change of) the current setting for
the attachment point. The position of the module within the hub, the setting
of the backplane divider switch(es), and the mode setting all affect which
backplane networks are valid. Some modules may limit the use of certain
backplane network(s) or local channel(s).
Last Change
Displays the value of SysUpTime when the last attachment change for the
attachment point was detected. If no change has been detected since cold/
warm start of the agent, the value is zero.
Port Profile View
The SynOptics FDDI Port Profile view contains information specific to each
port for the SynOptics FDDI 5000 series. This view provides the following
information:
Board
Displays the unique value for each board that contains FDDI ports.
Port
Displays the unique value for each port. This value ranges between 1 and n.
Partition Status
Displays the partition status of the port. The Partition value partitions the
port from ring. The Enable value allows the port to connect to the ring. If a
timed partition is desired, timedpart is written to this object at the same time
a time value is supplied.
Partition Time
Displays the duration of the port partition period.
PC Line State
Indicates the line state received by the port. Possible states are
Quiet_line_state, Idle_line_state, Master_line_state, Halt_line_state,
Active_line_state, Line_state_unknown, and Noisy_line_state.
Active Time
Displays how long this port has been active.
PCM Break Count
Displays the number of times the port enters the pcm break state.
PCM Active Count
Displays the number of times the port enters the pcm active state.