Specifications

9031398 E3 Event and Alarm Messages
6-5
Ethernet NMM Agent Events and Alarms
CsEvFormat/Event01020012
{d “%w- %d %m-, %Y - %T”} A port auto-
partition condition has been detected on {O
2} (board.port). The port partition status is
{T S5EPortPartS 1}. The port jabber status
is {T S5EPortJabberS 3}. {t} (name - {m}).
(Trap type: 0x01020012) - (event [{e}])
CsPCause/Prob01020012
ENET PORT AUTO PARTITION
PROBABLE CAUSES:
1) The port has been isolated by the
NMM from the network due to a faulty
device, excessive collisions, DTE
jabbering, or a wiring problem. This
could include bad connections, topological
loops or protocol issues, such as
broadcast or multicast echo requests.
RECOMMENDED ACTIONS:
1) Check or replace the network device
or the device’s transceiver that is
connected to the autopartitioned port.
2) Check or replace any wiring
problems such as bad connections or
topological loops.
CsEvFormat/Event01020013
{d “%w- %d %m-, %Y - %T”} Port {O 2}
(board.port) has detected an Ethernet DTE
is jabbering. The jabber status is {T
S5EPortJabberS 1}. {t} (name - {m}). (Trap
type: 0x01020013) - (event [{e}])
CsPCause/Prob01020013
ENET PORT DTE JABBERING
PROBABLE CAUSES:
1) An Ethernet port has been flagged as
jabbering. Jabbering occurs when a
station continues to transmit a signal.
RECOMMENDED ACTIONS:
1) Check or replace the network device
or the device’s transceiver.
2) Check or replace any wiring
problems such as bad connections.
Table 6-2. Ethernet NMM Agent Events and Alarms (Continued)
Message in the Event Log
Alarm Manager Probable Cause
Message