Installation guide

Remote Annex 4000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-14
console-baud
The console-baud command changes the console port’s baud rate.
Thus, the console port can interface with any modem to which it is
connected. When the baud rate is entered as auto, the Remote Annex
4000 detects the baud rate of the incoming line and adjusts its baud
rate accordingly. This command provides support for remote
troubleshooting. The command syntax is:
console-baud
The command display looks like this:
This command has no effect on the port’s baud rate after the
Remote Annex 4000 is booted.
monitor:: console-baud
Remote Diagnostic Test Mode
In order to use the remote diagnostic functionality, you
must first connect a modem to the console port of the Anne
x
The modem should be configured such that DTR is forced on,
carrier detect and DSR are set normal, and auto-answer is
enabled. Once this is done, contact your service
representative for remote diagnostic maintenance.
To enter “Autobaud Mode”, please type “Auto”. To “manually
”
configure the Annex console port, please type in the
desired baud rate. To return to the “monitor::”
prompt strike the “carriage return <CR>” key.
[Baudrate Range: 50–9600 BAUD]
Select Baudrate []: