Installation guide
3-13Remote Annex 4000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
config
Theconfigcommand displays the current configuration information
and revision levels. For each serial line controller (SLC), config
displays the port configuration as the number of PBX Champ
connectors, the range of port numbers for each champ, and the
amount of memory on the SLC. The config command display contains
information describing whether or not Flash ROM is installed. The
command syntax is:
config
Theconfig command display for a Remote Annex 4000 with two SLCs
looks like this:
19-24 25-30 31-36
monitor:: config
1-6 13-187-12
37-42
43-48 49-54
Number of Ports = 36 Number of Ports = 18
Amount of Memory = 1.5 MegAmount of Memory = 1.5 Meg
SLC 1 Type = VFSLC SLC 2 Type = VFSLC
Max Speed = 115.2 Max Speed = 115.2
-----------------------------------------------------
REVISION/CONFIGURATION INFORMATION
ROM Software Rev: 0901 Ethernet Add:00-80-2D-00-B5-9D
Board ID: 46 Major HW Rev: 4
MLB Type: Enhanced Ext MLB CPU Type: 486SXLC2
Amount of memory: 6 Meg EEPROM size: 65504
FLASH PROM size: 2 Meg MFG IDs: (8989,8989)
Available Interfaces (* = selected):*ThickNet ThinNet
Twisted Pair
RS232 RS232 RS232 RS232 RS232RS232 RS232 RS232RS232