Installation guide

3-3Remote Annex 4000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
Table 3-1. ROM Monitor Commands (continued)
(continued on next page)
Command Description Use
boot [-l] [<file>] Erases the existing
Flash memory and
copies a new image to
Flash.
Upgrading or
replacing the Flash
image.
config Displays the current
hardware
configuration and
revision levels.
Identifying your
hardware, memory,
and ROM versions.
console-baud Changes the console
port’s baud rate.
Configuring the
console port for
remote maintenance.
erase Erases non-volatile
memory.
Loading a new image
and need to erase the
old image.
help Displays the list of
ROM Monitor
commands.
Referencing the ROM
monitor commands.
image [-d | <file>] Displays and/or sets
the load image and
tftp load dump
names.
Loading an image
that differs from the
default.
ipx [-d] Displays and sets
EEPROM values
relevant to Novell/
IPX network
addressing, including
the IPX load/dump
file server.
Changing Novell/IPX
configuration
parameters.
lat_key [-d] Sets the LAT key. Connecting to a DEC
VMS host.