Installation guide

Remote Annex 4000 Hardware Installation Guide

Chapter 2 Installing the Remote Annex 4000

2-20

This section contains the following subsections:

❑ Installing to and Loading from a Novell Server.

❑ Installing to and Loading from a UNIX Host.

❑ Installing to and Loading from a VAX VMS Host.

Installing to and Loading from a Novell Server

This section contains a description of what you need to do to install

the Remote Annex 4000’s operational software and image to a Novell

Server. Proceed as follows:

1 Log into your Novell server as SUPERVISOR or equivalent.

2 Insert the Network Administrator Program Install Disk into your PC’s

ﬂoppy drive.

3 Change to your PC’s ﬂoppy drive (usually drive A or B).

4 Display or print the README.TXT ﬁle for updated information about

the current version of Annex Manager for DOS software.

5 Type INSTALL and press .

A list of your PC’s available drives appears.

6 Select a network drive that is accessible to all users on the network

and press .

7 Enter the name of the directory where you want to copy the ﬁles or

select the default \PUBLIC directory and press .

The installation program copies each ﬁle from the

Administrator’s Install Disks to the network drive and directory

you speciﬁed in Steps 5 and 6. The installation program then

decompresses and veriﬁes each ﬁle being copied. See the Annex

Manager for DOS Administrator’s Guide for the PC for a list and

description of the Administrator’s ﬁles.

8 Power up or reset the Remote Annex 4000. Do not enter test mode.

Ente