Installation guide

2-19Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
5 Record the Remote Annex 4000’s Ethernet address for future
reference.
At the monitor prompt, type addr -d and press . The screen
display looks like this:
Installing the Operational Software and Loading the
Image
Use this section if you have successfully connected the Remote Annex
4000 to your LAN.
This section describes:
❑ How to install the Remote Annex 4000’s operational software
and image on a device that resides on a network accessible
to the Remote Annex 4000.
❑ How to download the operational image from the network
device to the Remote Annex 4000.
Retur
n
monitor:: addr -d
Ethernet address (hex): 00-80-2D-00-18-B6
Internet address: <uninitialized>
Subnet mask: 255.255.0.0
Broadcast address: 0.0.0.0
Preferred Load Host address: <any host>
Preferred Dump Host address: 0.0.0.0
Load/Dump Gateway address: 0.0.0.0
Type of IP packet encapsulation: <ethernet>
Load Broadcast: Y