Installation guide

Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
2-18
If the Unit, Net, and Attn LEDs do not light within one minute,
one of the following failures has occurred:
❑ Remote Annex 4000 hardware failure: Unit and Attn
LEDs flash. Contact technical support.
❑ Network or network interface failure: Net and Active
LEDs flash; error message displays on the console.
If a network or network interface failure occurs, typing q accesses the
ROM Monitor prompt. Check the network connection (also, see
net
on page 3-22).
Chapter 4 provides additional troubleshooting
information.
4 Verify the Remote Annex 4000’s hardware configuration.
At the monitor prompt on the console, type config and press
. The screen display looks like this:
Retur
n
19-24 25-30 31-36
monitor:: config
1-6
RS232
13-18
RS232
7-12
37-42
43-48 49-54
RS232 RS232 RS232
Number of Ports = 36 Number of Ports = 18
Amount of Memory = 1.5 MegAmount of Memory = 1.5 Meg
SLC 1 Type = VFSLC SLC 2 Type = VFSLC
Max Speed = 115.2 Max Speed = 115.2
-----------------------------------------------------
REVISION/CONFIGURATION INFORMATION
ROM Software Rev: 0901 Ethernet Add:00-80-2D-00-B5-9D
Board ID: 46 Major HW Rev: 4
MLB Type: Enhanced Ext MLB CPU Type: 486SXLC2
Amount of memory: 6 Meg EEPROM size: 65504
FLASH PROM size: 2 Meg MFG IDs: (8989,8989)
Available Interfaces (* = selected):*ThickNet ThinNet
Twisted Pair
RS232 RS232 RS232RS232