Installation guide

2-15Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
Powering Up and Testing the Remote Annex 4000
Power-up and test your Remote Annex 4000 as follows:
1 Verify the Remote Annex 4000’s operational power range.
Check that the power select switch is set to the 110V position
for operation in the 90 to 130 VAC range, or to the 220V
position for operation in the 180 to 260 VAC range (see Figure
2-14).
Figure 2-14. Verifying the Remote Annex 4000 Operational Power Range
Setting the power select switch incorrectly can damage the
Remote Annex 4000.
Power Select Switch