Installation guide

Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
2-14
Connecting a Parallel Printer
The Remote Annex 4000 supports parallel printer interface cables
from Dataproducts and Centronics. Connect the Remote Annex 4000
to your parallel printer as follows:
1 Connect one end of the Dataproducts or Centronics parallel printer
cable to the Remote Annex 4000’s 25-pin printer port (see
Figure 2-13).
Figure 2-13. Connecting the Parallel Printer Cable to the Remote Annex 4000
2 Secure the connection by tightening the screws that connect the
cable to the printer port.
3 Connect the other end of the Dataproducts or Centronics parallel
printer cable to your printer.
Appendix A details the printer port’s signal/pin allocations.
Dataproducts printers do not use standard cables.
Appendix B describes the cables for the Remote
Annex 4000.