Installation guide

Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
2-8
2 Plug the RJ-45 connector into the console port located on the back
panel of the Remote Annex 4000 (
Figure 2-6).
When the connector clicks into place, the connection is secure.
Appendix A describes the console port’s signal/pin allocation.
Figure 2-6. Connecting to a Console Terminal
3 Turn on the Console Terminal and set the terminal to 9600 baud,
eight data bits, no parity, one stop bit, and XON/XOFF flow control.
The ROM Monitor assumes that this terminal is CRT-based and
displays the backspace (BS) character accordingly. See Chapter
3 for information on invoking the ROM monitor.