Installation guide

2-7Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
Connecting a Console Terminal
A console terminal is used to access the ROM Monitor and boot the
Remote Annex 4000 for the first time. Follow the steps in this section
to connect a console terminal to the console port located on the rear
panel of the Remote Annex 4000.
1 Connect the Console Terminal’s I/O connector to the RJ-45 cable
(the accessory kit includes a cable) using a Telco RJ wire to a DB-25
DTE drop adapter (see
Figure 2-5).
Figure 2-5. Connecting the RJ-45 Cable to the DB-25 DTE Drop Adapter