Installation guide

Remote Annex 4000 Hardware Installation Guide
Chapter 1 Introduction
1-12
Figure 1-7. Remote Annex 4000 Rear Panel
Rear Panel Components
Console Port
The Remote Annex 4000 has a separate console port with an 8-pin,
RJ-45 connector for attaching the console. The console port provides
access to the ROM Monitor commands when the Remote Annex 4000
is in test mode.
Diagnostic Jumper
This jumper is for Xylogics internal use only.
Printer Port
The Remote Annex 4000 provides a printer port with a 25-pin, female
connector. This port is software-programmable to support a standard
Centronics or Dataproducts parallel printer interface.
Fan
Console
Port
Printer
Port
Thick 
Ethernet
(10Base5)
AC Line
Socket
Power
Switch
Power
Select
Dress Panel Cover
Thin
Ethernet
(10Base 2)
Twisted Pair
Ethernet
(10BaseT)
Diagnostic
Jumper
Mode 
Jumper