Installation guide

C-9Remote Annex 4000 Hardware Installation Guide
Appendix C Port Upgrade Instructions
2 Set the Remote Annex 4000 to test mode by pressing the Test switch
on the front panel (see
Figure C-11). The Test LED should light.
To access test mode, press the Test switch within
3 seconds of either powering-up or resetting the
unit via the Test switch.
Figure C-11. Setting the Remote Annex 4000 to Test Mode
The Remote Annex 4000 runs its ROM-resident power-up
diagnostics:
❑ All LEDs, except for Power, light momentarily and then
turn off.
❑ The Active LED flashes to show that diagnostics are
running.
❑ If the diagnostics complete successfully, the Power, Unit,
and Net LEDs light. After about one minute, the ROM
Monitor prompt appears on the console terminal.
3 Issue the config command to verify the new hardware and
port configuration.
STATUS
POWER UNIT NET ATTN LOAD ACTIVE 12345678
TEST
Test Button