Installation guide

Remote Annex 4000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-32
Table 3-2. The slip Command Prompts
Prompt Description
Allow SLIP on this
port
Modifies the port’s mode. A y response changes
the port to a SLIP interface. An n response
changes the port’s mode to CLI. The port is not
available as a SLIP interface and the SLIP
parameters are ignored. The default is n.
Enter local endpoint
address
Specifies the Remote Annex 4000 Internet
address for this SLIP interface. The Remote
Annex 4000 boots over the SLIP interface only if
this address is set.
Enter remote
endpoint address
Specifies the Internet address of the remote end
of the SLIP interface.
Enter remote load/
dump host address
Specifies the Internet address of the remote host
to which load and dump requests are sent. This
address is required only if the remote host is a
gateway and not the load host. By default, this is
the same as the remote end-point address.
Should this interface
be used for memory
dumps
Enables the Remote Annex 4000 to use a SLIP
interface for memory dumps. The default is y.
Enter the baud rate Specifies the baud rate of the serial interface.
The default is 9600.
Enter the number of
stop bits
Pressing accepts the default (one).
Generally, SLIP implementations require the
default.
Enter the parity
Pressing accepts the default (none).
Generally, SLIP implementations require the
default.
Retur
n
Retur
n