Installation guide

3-31Remote Annex 4000 Hardware Installation Guide

Chapter 3 ROM Monitor Commands

slip

The slip command defines a serial port as a Serial Line Internet

Protocol (SLIP) interface. The command automatically sets the

number of data bits to 8 for all SLIP interfaces. The number of data

bits does not include the start, stop, or parity bits.

Table 3-2 lists the

information for which the slip command prompts. The syntax is:

slip [–d] [port]

The slip –d command displays all of the current settings.

After entering the slip command, you are prompted for each

parameter. The port is the number of the serial port to be configured

with this command. If you do not enter a port number, you are

prompted for one. The slip command display looks like this:

Pressing -C interrupts the slip command; the

parameters remain unchanged until the command

completes normally.

monitor:: slip

Line number (1–16)::6

Allow SL/IP on this port? (y/n) [n]::y

Enter local endpoint address [0.0.0.0]::192.9.200.214

Local endpoint address: 192.9.200.214

Enter subnet mask [255.0.0.0]::

Constructed new subnet mask.

Enter remote endpoint address [0.0.0.0]::192.9.200.0

Remote endpoint address: 192.9.200.0

Enter remote load/dump host address [default

192.9.200.88]::

Remote load/dump host address: 192.9.200.88

Should this interface be used for memory dumps? (y/n) [y]::

Enter the baud rate [9600]::

Enter the number of stop bits (1,1.5,2) [1]::

Enter the parity (none,even,odd) [none]::

WARNING

Contro