Owner Manual

Step 5
Cover the Bolts(①) and Bolts(②) using Caps(⑥).
Step 3
Place the Seat(B) facedown.
Align the Seat(B) to Chair Legs(C) as shown above.
Attach Seat(B) to Chair Legs(C) using Bolts(①), Spring Washers(⑤) and Washers(④) with Allen Key(③).
Note: The front Legs are high and the back low.
Do not fully tighten the Bolts.
Step 4
Stand the Chair up.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Legs and Seat reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
Page 4 OF 5