Assembly Instructions Caution: You must read this before you proceed Chair Picture Part List Label Picture Description QTY A Backrest 1 B Seat 1 C Chair Legs 1 D Seat Cushion 1 E Back cushion 1 Page 1 OF 5
Hardware Label Picture Description QTY ① Bolt (M6X20mm) 5 ② Bolt (M6X30mm) 5 ③ Allen Key 1 ④ Washer 9 ⑤ Spring Washer 9 ⑥ Cap 9 Assembly Preparation Before Beginning Assembly: ×5 ×5 ×9 ×9 ×9 Page 2 OF 5
Assembly Steps Overview Backrest (A) Seat (B) Back cushion (E) Seat Cushion (D) Chair Legs (C) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 3 Place the Seat(B) facedown. Align the Seat(B) to Chair Legs(C) as shown above. Attach Seat(B) to Chair Legs(C) using Bolts(①), Spring Washers(⑤) and Washers(④) with Allen Key(③). Note: The front Legs are high and the back low. Do not fully tighten the Bolts. Step 4 Stand the Chair up. Exert pressure floorwards, onto the Chair with both your hands. This pressure will help the Legs and Seat reach full alignment status. Check for wobbles on a LEVEL surface.
Step 6 Stand the Chair up. Put the Seat Cushion(D) onto the Chair. Secure the Seat Cushion using the Velco straps as pictured. Step 7 Place the Back Cushion(E) on the Chair. Your Chair is ready for use. This Chair can only be used on a flat and level surface.
