Assembly Instructions

ManualsBrandsBay Isle Home ManualsOutdoor & Patio FurnitureBushnell 30" Patio Bar Stool

Caution : You must read this before you proceed

CHAIR

CAUTION : This Chair is NOT a TOY.

Keep your child / children at bay during the assembly process.

For moving the Chair and to prevent damage to the Chair, two adults are needed

to execute this action.

___

Summary of content (7 pages)

PAGE 1
Caution : You must read this before you proceed CHAIR CAUTION : This Chair is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Chair and to prevent damage to the Chair, two adults are needed to execute this action.
PAGE 2
Label Picture Description QTY A Seat Frame 1 B Legs 2 C Cross Bar Of Legs 2 Label Picture Description QTY ① Bolt (M6x45mm) 9 ② Washer 5 ③ Screw (M6 x 55mm) 3 ④ Allen key with a round head 2 2 ___
PAGE 3
Before Beginning Assembly: Before Beginning Assembly: OVERVIEW Seat Frame (A) Leg (B) Cross bar of legs (C) FRONT FACING This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Chair, the above picture is to assemble is to help you put the various parts into perspective. Please read through the instructions here below to familiarise the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 Place Seat Frame (A) with its underside skywards onto a clean, soft surface to avoid any scratch or damage to the product. Attached Leg (B) with pre-fixed wooden dowel to the Seat Frame (A) as pictured above. Secure by using Bolts (①), washer (②), and Allen Key (④) DO NOT FULLY TIGHTEN THE BOLTS.
PAGE 5
Step 3 Attach the cross bars of legs (C) to in assemble part by using Bolts (①) and Allen key (④) DO NOT FULLY TIGHTEN THE BOLTS. FULLY TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT. ONLY TIGHTEN UNTIL SECURE. Step 4 Then place complete part in step 2 into the tenon of side rails and the leg (B). 4.1 Using Bolts (①), washer (②) and Allen Key (④) to attach the seat frame (A) to the complete part in step 3. 4.
PAGE 6
Step 5 Finally, using Screw (③) and Allen key (④) to strengthen seat top Panel. DO NOT FULLY TIGHTEN THE SCREW. Step 6 If wobble Test again 30cm-50cm Place the Chair right side up on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Chair 30cm to 50cm high from the ground. Keep your feet and toes well away from the drop zone. Drop the Chair freely and vertically with all four legs, hitting the ground at the same time.
PAGE 7