Technical data

10.0 Changing Components
21
10.1 Changing Components
WARNING: Isolate the gas and electricity
supplies to the boiler and fire unit before
changing any components.
1. Lift the controls access door away from the
fender assembly (Fig. 59).
2. Turn off the gas supply at the service cock
(Fig. 60).
3. Carefully remove all the loose coals, side
cheeks, rear and front coals (Fig. 58).
CAUTION: The coals are extremely fragile
and must be handled accordingly. Gloves
should be worn and any inhalation of the dust
should be avoided. Keep the coals away from
children at all times. Never use coals other
than those originally supplied or Genuine Baxi
Spare Parts. Never put additional coals on the
fire. Please read section 1.3 Important
Information.
4. Remove the glass retaining assembly
(Fig. 62). At this point the bulb/s may be changed
(see Section 10.7).
5. Carefully remove the three amber glass pieces
(Fig. 63).
6. Lift the fender assembly to disengage the
hooks and remove it (Fig. 59).
7. At this point the burner and injector may be
changed.
8. Disconnect the gas supply to the fire at the gas
service cock connection (Fig. 61).
Fender Assembly
Fig. 58
Fig. 59
Controls Access Door
Gas Service Cock
Fig. 60
Fig. 61
Fire Gas Supply Pipe
Gas Service
Cock
OFF Position
Glass Retaining
Assembly
Amber Glass Pieces
Fig. 62
Fig. 63
Amber Glass
Pieces