Technical data

9.0 Annual Servicing

9.5 Cleaning the Combustion Box &

Coals

1. Remove any deposits from the firebed base

panel (Fig. 52).

2. If necessary the coals can be cleaned with a

very soft brush, and can be retouched using the

black stain available direct from Baxi or from your

local Baxi Spares Stockist. Quote Part N

043224

when ordering.

3. Refit the burner to the controls mounting plate

(Fig. 53).

9.6 Replacing the Fire

1. Once the boiler has been serviced, the fire can

be replaced. Refer to the boiler installation and

servicing instructions.

2. Slide the fire combustion box into position

ensuring that the flue spigot fits into the boiler

downdraught diverter. Fit and tighten the two

screws inside the flue spigot (Fig. 54) and

replace the two screws into the boiler base tray

(Fig. 56).

3. Reconnect the gas supply and test for

soundness (Fig. 57).

4. Reconnect electrical supply (Fig. 55).

5. Replace all the loose coals, side cheeks, rear

and front coals as described in “Arranging the

Coals”. Refit the fender assembly.

Retaining

Screw

Burner

Firebed Base Panel

Fig. 52

Fig. 53

Fig. 57

Fig. 56

Fig. 55

Control Box

Fire Gas Supply Pipe

Gas Service

Cock

Flue

Spigot

Boiler Hood

Fig. 54

Base Tray Securing Screw