Technical data

5.0 Installation
14
5.1 Initial Preparation
1. Unpack contents of carton.
2. Remove the lower door panel from the outer
case. Remove the 2 screws holding the outer
case to the combustion box.
3. Place the ready assembled outer case in a
safe place until required.
4. Release the R clip from the top latch securing
the combustion box to the back plate and
release both latches (Fig. 15).
5. Lift and remove the combustion box from the
back plate (Fig. 16). Place the combustion box
on its back.
IMPORTANT - When installing a Solo 3 PFL
with a rear flue see section 5.2 before
continuing the installation.
6. Proceed to the relevant section for flueing the
appliance either to the Rear, Left, Right or
Vertically.
NOTE: For Vertical flueing or flue lengths
greater than standard, the relevant optional
extra kits must be obtained and their
instructions followed.
Fig. 15
Fig. 16