Quick Start Manual

7.0 Site Requirements

7.7 Flue Dimensions

The standard horizontal flue kit allows for flue lengths

between 100mm and 1m from elbow to terminal

(Fig. 12).

The maximum permissible equivalent flue length is:

Instant 80e 5 metres

Instant 105e 4 metres

NOTE: Each additional 45° of flue bend will

account for an equivalent flue length of 0.5m.

eg. 45° = 0.5m, 90° = 2 x 45° = 1m etc.

7.8 Flue Terminal Trim

1. Once the flue is secure the trim can be fitted if

required.

2. Remove the protective backing from the adhesive

seal. Apply the seal to the rear of the trim flange

(Fig. 13).

3. Locate the trim over the flue terminal and push it

back to the wall to compress the seal (Fig. 14).

7.9 Terminal Guard (Fig. 15)

1. When codes of practice dictate the use of terminal

guards, they can be obtained from most Plumbers’ and

Builders’ Merchants.

2. There must be a clearance of at least 50mm between

any part of the terminal and the guard.

3. When ordering a terminal guard, quote the appliance

name and model number.

3. The flue terminal guard should be positioned

centrally over the terminal and fixed as illustrated.

Fig. 12

Fig. 15

100mm

Fig. 14

Fig. 13

Flue Trim

Adhesive Seal