Technical data

Genesis Baxi Heating Ltd.

INSTALLATION – Page 19

Fitting The Boiler

Lift the boiler using the lower edge of the combustion box

and the hand holds in the chassis.

Place boiler on the support bracket, slide back then lift to

engage on top hooks.

Hinge down the electrical box to gain access to the

connections between boiler and valves.

At both sides push in the two tabs - hinge box down by

rotating.

Check the inlet water filter is fitted (F).

Make the gas connection first (G). This will centralise the

boiler.

Insert the sealing washers between the valve outlet face and

the flange on the copper bends. The rubber washer is for

use on the gas connection only. The fibre washers are

for the water circuit connections.

Tighten the connections.