Technical data

8.0 Installation

8.7 Fitting the Flue (Cont)

6. Ensure the inner flue support bracket is positioned in

the flue (Fig. 28).

7. Engage the flue into the flue elbow using soap solution

to ease the engagement ensuring the flue is assembled as

shown (Fig. 29).

8. Place the gasket over the flue exit on the boiler.

9. Slide the flue assembly through the hole in the wall.

10. Engage the elbow on to the flue connection on top

of the boiler. Secure with the four screws supplied in the

kit.

11. Make good between the wall and air duct outside the

building ensuring the 3° drop between the terminal and

elbow.

12. The flue trim should be fitted once the installation is

complete and the flue secure (Fig. 30). Apply a suitable

mastic to the inside of the trim and press against the wall

finish, making sure the brickwork is dust free and dry.

13. If necessary fit a terminal guard (see Section 7.9).

VERTICAL FLUEING

1. Only a flue approved with the Baxi 50, 80 and 100/2

HE Plus can be used.

2. For information on vertical flues consult the Baxi Flue

Guide Brochure or Notes for Guidance supplied with the

vertical flue pack.

Gasket

Flue Trim

Inner Flue Support Bracket

Flue

Flue Elbow

Fig. 28

Fig. 30

Fig. 29

Apply Lubricant for ease of

assembly. Ensure Flue is fully

engaged into Flue Elbow.